Step 01
Attach the Nasal Dock by pressing it into the Mechanical Module. The rest of your Nose Cleaner is already assembled, including the batteries.
Panier
Votre panier est vide
Attach the Nasal Dock by pressing it into the Mechanical Module. The rest of your Nose Cleaner is already assembled, including the batteries.
Fill the Upper Tank to the Fill Line with warm water.
Place a new Naväge SaltPod capsule in the Crushing Chamber, foil-side down.
The device will
not work without a new, unused SaltPod in the crushing chamber.
Close the Lid firmly until you hear it click and do not reopen it.
Gently shake the device for a second or two to mix the SaltPod contents with the water in the Upper Tank.
Tip: Run a little water over the Nose Pillows to make them easier to slip into your nostrils.
Arrows on the Nasal Dock indicate the direction of flow. Note that the rinse goes into the nose through one Nose Pillow, and out of the nose through the other.
Locate the Power Button and firmly push the button in. The pump will start, and the Drain Valve will open, causing saline to flow from the Upper Tank into one nostril, around the back of the nose, and out the other nostril into the Lower Tank. The first few times do this in front of a mirror and over a sink to get the hang of it.
When the upper tank is empty, the cycle is complete.
When you’re finished, release the Power Button and remove the Nose Pillows from your nostrils. You may have a little saline left in your nasal passages, tilt your head forward and gently blow your nose.